Owner`s manual

INSTALLATION (cont.)

36" LOG SET

You must position and maintain the log layout as shown here to ensure proper operation of the direct

vent insert. Incorrect log installation could cause ﬂ ame impingement and improper combustion, resulting

in soot and/or excessive by-products of combustion.

Note: Each log is numbered (on the log bottom) to aid in placement. Burnt American Oak log set shown here.

Important: HANDLE LOGS WITH CARE AT ALL TIMES.

Place the rear log (log #1) as shown. The bottom

of the log has two holes that align with two pegs

found on the rear burner.

Place the front right log (#2A) followed by the front

left log (#2B) as shown. The bottoms of each log

have two holes that align with two pegs found on

the front burner.

Place the middle log (log #3) as shown. The rear

log has a notch to aid in positioning the log.

Place the right top log (log #4) as shown.

Place the middle top log (log #5) as shown. Place the left top log (log #6) as shown.

Separate the bryte coals into small pieces and

evenly place them in the area shown above.

Periodically check the positioning of the logs to ensure proper log placement.

2A2B