Owner`s manual

31
GLOWING EMBERS
D1-25 Models:
1. Separate the glowing embers into small pieces and
evenly place them along the burner ports as shown
in Fig. 31-1.
2. Separate the bryte coals into small pieces and evenly
place them along the very front of the burner / glowing
embers as shown in Fig. 31-2.
CAUTION: The embers must be placed as shown. DO
NOT add any additional embers for this
installation. Any additional embers will cause
unsafe operation.
D1-30/36 Models:
Important: Prior to placing the glowing embers, ensure
the ember screen that rests in between the
front and rear burner is properly positioned.
See Fig. 31-3 for details.
1. Separate the glowing embers into small pieces and
evenly place them along the burner ports as shown
in Fig. 31-4.
For D1-30/36 models, the bryte coals are not placed
until after the logs are installed.
CAUTION: The embers must be placed as shown. DO
NOT add any additional embers for this
installation. Any additional embers will cause
unsafe operation.
INSTALLATION (cont.)
Fig. 31-1 D1-25: Place glowing embers
Fig. 31-2 D1-25: Place bryte coals
Fig. 31-3 D1-30/36: Proper screen position
Fig. 31-4 D1-30/36: Place glowing embers
Separate embers and
place as shown here
Center screen
around 2 holes
Separate embers and
place as shown here