Owner`s manual

30
INSTALLATION (cont.)
8. Place the top panel into the unit as shown in Fig. 30-1,
"C". It will be supported by the left panel.
9. Place the right panel on the right side of the unit.
Ensure it completely rests inside of the front lip of the
unit. See Fig. 30-2, "D".
10. Re-install the lintel at the top front of the unit. Use the
two existing hex screws and a
5
/
16
" nut driver. See
Fig. 30-3, "E".
11. Re-install the burner(s) and ember screen (if applicable).
Use the existing hex screws and a
5
/
16
" nut driver for
the burner. See Fig. 30-4, "F" and "G".
12. Re-install the front fl oor panel at the front of the unit
fl oor. Ensure it completely rests inside of the front lip
of the unit. See Fig. 30-4, "H".
13. Re-install the grate in between the front burner and
front fl oor panel. Use the two existing screws and a
Phillips screwdriver. See Fig. 30-5, "I".
14. Install the left and right fl oor panels on each side of the
burner assembly. See Fig. 30-5, "J" and "K".
Fig. 30-1 Place top panel
Fig. 30-3 Install lintel
Fig. 30-2 Place right panel
Fig. 30-5 Grate, left/right fl oor panel
J
K
I
Fig. 30-4 Install burner(s), screen, front fl oor panel
G
H
F
E
Align
Screw
D
C
Insert left corner, then
raise panel into place