Owner`s manual

INSTALLATION (cont.)

INSTALL BATTERIES

Ensure all control/remote system components are in the

OFF position prior to installing any batteries.

Remote transmitter:

The remote transmitter requires 3 AAA batteries (included)

to operate.

1. Locate the remote transmitter, remove the lid (found

on rear), and properly insert the batteries as marked.

Re-secure the lid. See Fig. 27-1.

Remote receiver:

The remote receiver requires 4 AA batteries (included)

to operate. Turn off gas to the unit. Locate the receiver

on the control box, which is located on the left side of the

unit (see Fig. 27-2).

2. Slide the 3-position switch on the receiver to the ON

position, then remove the switch. Unfasten the plastic

plate using a Phillips screwdriver. See Fig. 27-3.

Remove the battery lid (push in tabs) and properly

insert the batteries as marked (see Fig. 27-4). Re-

secure the lid, the plate, and the switch.

PRG

ON REMOTE OFF

Fig. 27-2 Control box (left side of unit)

Remote

receiver

(Direct

vent

insert)

Fig. 27-3 Remove switch and plate

for battery access

PRG

ON REMOTE OFF

Fig. 27-1 Install transmitter batteries

Remove lid

for battery

access

Move to ON

position, then

remove

Unscrew,

then remove

plate

Battery lid

Fig. 27-4 Install receiver batteries