Operating instructions

13
MANUAL LIGHTING
CAUTION: Always wait 5 minutes for gas to
clear after any unsuccessful lighting
attempt.
1. Follow steps 1 through 4 (left).
2. Insert either a burning long-barrel butane lighter, a
burning long-stem match, or a burning match held
by a wire extension holder (Fig.
13-2) through
the cooking grids to the burner (Fig. 13-3).
For backburners, hold the flame against the
perforated material of the backburner.
For sideburners, hold the fl ame against the burner.
3. While holding the match or lighter fl ame next to
the burner, depress the appropriate burner control
knob and turn it counter-clockwise to the HI LIGHT
position. When the burner lights, remove the lighter
or match.
4. If the burner does not light, IMMEDIATELY depress
the knob and turn the burner control knob to OFF.
WAIT 5 MINUTES before repeating steps 2 through
4 of the MANUAL LIGHTING INSTRUCTIONS.
Note: Barbecues in some installations achieve a
better air/gas mixture and will ignite more
quickly if the burner control knob is fi rst turned
beyond HI LIGHT to LOW for lighting.
ELECTRONIC LIGHTING
1. Open all lids and remove all covers from the burners
you wish to light.
2. Turn all gas control knobs to their OFF positions.
3. Turn on the gas at its source.
Note: No matter which lighting method you use,
DO NOT turn
on the gas to
more than one
burner at a time.
Adjacent
barbecue
burners will
cross-ignite and
gas flow may
be restricted.
CAUTION: If the burners do not light within 5
seconds, depress the control knob and
turn the knob to OFF. WAIT 5 MINUTES
before repeating step 4. If you smell
gas, follow the instructions on the cover
of this manual. If the burners still do not
light after several attempts, refer to the
instructions for MANUAL LIGHTING.
4. Depress the control knob for the burner to be lit
and turn it to the HI LIGHT position, then press the
ignition button. Once the burner lights, release the
ignition button.
5. Repeat step 4 for each additional burner to be lit.
FOR PROPANE ONLY
Propane tanks are a equipped with a safety shut-down
device that may cause low or no gas pressure/fl ame
at the burners if operating and lighting instructions
are not followed exactly (See important note in the
TROUBLESHOOTING section for more details.)
ADJUSTING THE FLAME
The knobs on the face of the barbecue control the valves
and adjust the fl ame height. The fi rst labeled position
is OFF, the second HI LIGHT, and the third LOW. In
between the HI LIGHT and LOW labels are mid-point
marks. Flame height can be set anywhere between the
HI LIGHT and LOW settings.
The height of the fl ame with a valve in LOW position
may be further regulated by means of a small adjusting
screw in the center of the valve stem. This screw is
accessible by removing the valve knob, which pulls
straight off the end of the valve stem.
REMEMBER: FOR SAFE MANUAL LIGHTING, PLACE A
BURNING MATCH OR BUTANE LIGHTER BESIDE THE
BURNER - THEN TURN ON THE GAS (see Fig. 13-3).
Fig. 13-2 - Match holder
Read entire instructions before lighting and follow these instructions each time you light the barbecue.
LIGHTING (IGNITION) INSTRUCTIONS
Fig. 13-3 - Manual lighting
Fig. 13-1 - Valve control knob
OFF
HI
LIGHT
LOW
TO TURN OFF
TO TURN ON
READ SETTING
HERE
HIGH TO
LIGHT
Read setting
here
TO TURN OFF
TO TURN ON
High to
light
SHUTTING OFF THE GRILL
To shut off the grill, push in each valve control knob and
turn it clockwise to the OFF position.
Always close the valve to the gas supply after each use
of the barbecue.