Operating instructions
10
CONNECT THE GAS SUPPLY TO THE BARBECUE 
a. You will need an approved flex connector 
(attached before shipping) to bring the gas 
supply from the gas line stub to the valve 
manifold.
WARNING
A rubber or plastic connector will rupture or 
leak, resulting in an explosion or serious injury, 
if used inside the barbecue enclosure. 
b.  With the gas supply shut OFF, slide the clamp 
ring over the gas supply hose.
c. Push the gas supply hose fully onto the EU 
adapter.
d.  Slip the clamp ring back down the gas supply 
hose until it is around the EU adapter where 
the hose connects to it; then tighten the clamp 
ring using a standard screw driver so that the 
hose stays fi rmly attached to the EU adapter.
e.  Make sure the barbecue burner valves are in 
the OFF position. Turn the gas supply on. Then 
carefully check all gas connections for leaks 
with a brush and soapy water before lighting. 
NEVER USE A MATCH OR OPEN FLAME TO 
TEST FOR LEAKS.
f.  Slide the barbecue into place, making sure not 
to pinch or kink the attached gas connector. 
g. Refer to the AIR SHUTTER ADJUSTMENT 
instructions and LIGHTING INSTRUCTIONS of 
this manual before replacing the barbecue face 
and knobs.
INSTALLING YOUR FIRE MAGIC DELUXE GOURMET SERIES BARBECUE
Fig. 10-2 Flavor grid diagram
OFF
HI
LIGHT
L
O
W
OFF
HI
LIGHT
L
O
W
INSTALL THE FLAVOR GRID
Place the flavor grid directly on the burners. 
Center the grid over the burners with the open 
side up. This allows heat from burners to be evenly 
distributed through cooking area. The fl avor grid 
heats and cools quickly, making your Fire Magic 
barbecue very responsive to the changes you 
specify in grill temperature.
The fl avor grid is made of stainless steel or coated 
with high temperature porcelain. Either fi nish is 
rust resistant and may be cleaned with standard 
oven cleaners.
DRIP COLLECTION SYSTEM 
The drip collector in this Fire Magic barbecue 
is part of the unit’s main frame, and is located 
below the burners. The drip collector has one 
hole that allows excess drippings to fall through 
during cooking. The drip collector is also useful as 
it allows you to brush or scrape off excess dried 
residue inside the barbecue directly into the drip 
tray.
Fig. 10-1
1/2" fl are connector
1/2" fi tting
EU adapter
clamp
Gas supply hose
Exploded View
Required 1/2" fl exible 
stainless steel connector 
(factory installed)










