Owner`s manual

21
WOOD CHIP PLACEMENT
The decorative wood chips that are provided with the log set are for aesthetics only and do not affect operation
of the G18 series unvented gas log set. The wood chip with the circular design should be placed in front of
the valve, with at least a
1
/
2
" between it and the valve. The other wood chip should be placed on the opposite
side (see Fig. 21-4).
Note: The wood chips may be HOT during and
directly after operation of the gas log set.
Do not place the wood chips on or in the
log set.
LOG PLACEMENT
Log placement is critical to ensure stability of the logs and proper performance of your Real-Fyre
®
gas log
set. Be sure to follow the log placement instructions carefully!
1. Each log in the Real-Fyre
®
unvented gas log set is numbered to aid in the log placement procedures.
Set the rear log at the back of the burner. Slide it forward so that the rear of the main burner bracket fi ts
into the two (2) locating grooves in the front face of the log. Align the bottom of the front log with the
corresponding holes found in the burner. (See Fig. 21-1.)
INSTALLATION (Cont.)
1
2
Fig. 21-1
2. Position the top left log (Log #3) on top of the bottom logs. Locate the log so that it rests in the corresponding
slots on the bottom front log and bottom rear log (see Fig. 21-2).
3. Position the top Y-shaped log (Log #4) across the log set as shown. Position the top center log (Log
#5) across the front log and log #4. The logs should rest in the corresponding slots. (See Fig. 21-3).
16/18"
LOG SET
(EFV shown)
5
Fig. 21-2
After setting the logs into position as described above, ensure each is properly and fi rmly seated. Your unvented
gas log set will not function as intended if the logs are not correctly positioned. When placed properly, the
fl ames will not strike any portion of Logs # 3, 4, or 5. Periodically check the positioning of all logs to ensure
proper log placement and stability. If any fl ame is striking any of the logs, recheck the log placement. Adjust
to conform with instructions. There should be no fl ame touching these logs.
CAUTION: BURN HAZARD. Logs will remain hot for some time after use. You must maintain the log
layout as shown to ensure proper operation of your log set. If you need to reposition any
log to maintain the proper layout, use heat-resistant gloves or allow logs adequate time to
cool before handling.
4
3
Fig. 21-4
A
Ensure notches in face of
REAR log slide over rear
of bracket
AA
Fig. 21-3