Owner`s manual

20
FIREPLACE INSTALLATION (cont.)
Liners & Chimney / Mantel
1. Install the fi rebox liners into the interior of the fi rebox
in the order shown in Fig. 20-1 or Fig. 20-2 depending
on your model:
Fig. 20-1: Phoenix & Mariposa models with Chimneys,
and ALL unvented models
Fig. 20-2: Vented Phoenix w/ Back Venting models
• The bottom and rear liners have grooves to assist in
placement.
• The two shims "D" are to be installed by hand as
shown.
• Be sure to pull the fl ex connector inside of the fi replace
body through the liner and into the open interior of the
fi rebox (for later R.H.P. burner installation).
• For Unvented & Phoenix w/ Back Venting Fireplaces:
An additional liner / panel "E" exists and is to be
installed onto the top of the fi rebox (through the top
of the body piece).
Note: The liners rest in place. No hardware is required.
2. Place the chimney / mantel piece on top of the body
piece (no hardware required). See Fig. 20-3.
Recessed Fireplaces Only - Install Finish Substrate
For recessed fi replace models, install the fi nishing substrate as
appropriate. CONSULT A PROFESSIONAL CONTRACTOR
FOR YOUR INDIVIDUAL SETUP.
Fig. 20-1 Install fi rebox liners
Fig. 20-3 Place chimney / mantel
A
B
C
C
E
Be sure to pull fl ex
connector through liner
Unvented fi replaces
contain a liner for the
top of the fi rebox.
Fig. 20-2 Install liners (Vented Phoenix w/ Back Venting)
See Fig. 20-2 for Vented Phoenix
w/ Back Venting Liner Details
D
D
A
B
C
C
E
Be sure to pull fl ex
connector through liner
D
D
Vented Phoenix w/ Back
Venting fi replaces contain
a rear vent diverter panel
for the top of the fi rebox.