Owner`s manual

FIREPLACE INSTALLATION (cont.)

For standard models proceed to the LINERS &

CHIMNEY / MANTEL section. For Grand models,

continue on to the following section.

Grand Models ONLY - Side Walls

1. Locate the four pieces required to assemble one complete

side wall.

2. Place the rear side-wall piece beside the ﬁ replace body

as shown. Carefully align the pilot holes, and repeat the

hardware installation process (large bolts). See Fig. 19-1.

3. Place the front side-wall piece beside the ﬁ replace body

as shown. Carefully align the pilot holes, and repeat the

hardware installation process (large bolts). See Fig. 19-2.

4. Place the end side-wall piece against the front and rear

side-walls as shown in Fig. 19-3 (no hardware required).

5. Slide the top side-wall piece onto the front and rear side-

walls as shown in Fig. 19-4 (no hardware required). This

will secure the entire side wall.

6. Repeat assembly for the opposite side.

Fig. 19-1 Assemble rear side-wall (skip if n/a)

Fig. 19-2 Assemble front side-wall (skip if n/a)

Fig. 19-3 Assemble end side-wall (skip if n/a)

Fig. 19-4 Assemble top side-wall (skip if n/a)

Grand Models Only:

Side Walls

Bolt Kit

Qty.

x 3

Bolt Kit

Qty.

x 2