Owner`s manual

18
FIREPLACE INSTALLATION (cont.)
Connect Gas Supply
Important: Before installation, be sure the gas supply
(propane or natural) is turned off at its source.
Important: Locate the gas supply line out of pathways
where people may trip over it or in areas
where the line may way be subject to
accidental damage (if applicable).
The fi replace has a key valve pre-installed on either the right
or left side of the fi replace. For fi replaces that have the rear
gas line option, a
1
/
2
" rigid gas pipe is pre-installed to the
valve and protrudes out of the rear of the unit.
(A fl ex connector is pre-attached to the key valve on the
interior of the fi replace. An R.H.P. burner is to be connected
to it at a later time.)
1. Route the gas supply (natural gas, household propane,
or from an L.P. Cylinder) to the unit as applicable.
For rear installs, see Fig. 18-1.
For underneath installs, see Fig. 18-2.
Observe all codes and ensure all appropriate connections
are used to properly connect the gas supply. Apply only joint
compounds that are resistant to all gasses to all male pipe
fi ttings except fl are fi ttings. Make sure to tighten every joint
securely and properly leak test at all connections.
Important: This fireplace does not accommodate
propane cylinders. If a cylinder is used it must
be located in a safe location.
Fig. 18-1 Route gas supply (rear install)
(key valve
location
may vary)
Fig. 18-2 Route gas supply (underneath install)
(key valve
location
may vary)
Key valve
Flex
connector
Connect
here
Connect here
(from below)
Key valve
Flex
connector