Owner`s manual

17
FIREPLACE INSTALLATION (cont.)
FIREPLACE ASSEMBLY - STEP BY STEP
CAUTION: Fireplace components are heavy.
CAREFULLY handle all components during
assembly.
Note: A Phoenix Fireplace with a 16" Radiused Bullnose
Hearth is primarily depicted here. Your assembly may
slightly vary depending on model and hearth selected.
Hearth and Body
1. Locate the hearth or hearth pieces in an appropriate
location (refer back to the LOCATION section if needed).
For one-piece hearths, step 2 is not applicable: proceed
to step 3.
2. Arrange the hearth pieces in their proper position.
Carefully align the pilot holes, and insert the hardware
(large bolt kits) in the order shown in Fig. 17-1. Hand
tighten, then use two
3
/
4
" open end wrenches (or
equivalent) to fasten.
Note: The hearth pieces have access openings that allow
for assembly.
3. Place the body piece on top of the hearth. Carefully align
the pilot holes, and insert the hardware (large bolt kits)
in the order shown in Fig. 17-2. Hand tighten, then use
two
3
/
4
" open end wrenches (or equivalent) to fasten.
Fig. 17-1 Assemble hearth (if required)
Fig. 17-2 Assemble body
Bolt Kit
Qty.
x 4
Bolt Kit
Qty.
x 8