Owner`s manual

7
L-A2-159
REV 6 - 1301300913
ITEM
NO.
DESCRIPTION
1. Front bottom log
2. Rear bottom log
3. Left middle log
4. Right middle log
5. Left top log
6. Right top log
7. Top center log
EMBER PLACEMENT
Sprinkle the glowing embers (see PARTS LIST) lightly and evenly
over the entire surface of the ember burner screen. Break up any
clumps that may have developed during shipment. Bryte Coals
TM
should be placed over the glowing embers, also spread out evenly (Fig.
7-1). Failure to follow these instructions will result in unsafe operation.
Important: Do not add any additional embers or Bryte Coals
TM
to this log set. Any additional embers may cause
unsafe operation.
LAVA ROCKS (DECORATIVE)
Spread the lava rocks (see PARTS LIST) on the bottom of the fi replace, around (but NOT on) the upper
burner pan.
Note: It is OK to allow lava rocks onto the portion of the burner that is resting directly on the fi replace
fl oor, as long as they do not interfere with the controls.
IMPORTANT
For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The time
needed to purge will depend on the length of the gas line to the unit and the amount of time since the unit or
gas line was last used. It may take several minutes before all the air is purged and the pilot will light and burn
properly. Reference the LIGHTING INSTRUCTIONS section in this manual.
EMBER & LAVA ROCK PLACEMENT
Note: The log set is packed separately.
LOG LIST
N t Th l t i k d t l
1
2
3
5
4
Fig. 7-1
Lava rocks OK
Ember burner pan
Platinum
Embers
1
2
3
4
5
6
7
24" & 30" Log Sets
(CHFR-24 shown)
ITEM
NO.
DESCRIPTION
1. Front bottom log
2. Rear bottom log
3. Left middle log
4. Right middle log
5. Top center log
16/18" Log Sets
(CHFR-16/18 shown)