Owner`s manual

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion can result,

causing property damage, personal injury, or loss of life.

MANUAL LIGHTING INSTRUCTIONS

BEFORE LIGHTING, smell all around the burner area for gas. Be sure to smell next to the ﬂ oor as some

gas is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS

ON P. 1.

Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in

or turn by hand, don't try to repair it. Call a qualiﬁ ed professional service technician. Force or attempted

repair can result in ﬁ re or explosion.

Do not use this appliance if any part has been underwater. Immediately call for a qualiﬁ ed professional

service technician to inspect the appliance and to replace any part of the control system and any

gas control that has been underwater.

FOR YOUR SAFETY, READ BEFORE LIGHTING

LIGHTING THE BURNER

If the Real-Fyre

glass burner set is operated

by the ﬁ replace valve (natural only):

1. Lay a lighted long-stem match on the surface

of the glass near the gas inlet (do not hold

the match in your hand), or use a lighted

long-necked butane lighter.

2. Turn on the gas at the source.

3. If the burner does not light before the match

goes out, immediately turn off the gas at the

source.

4. Wait approximately ﬁ ve (5) minutes to clear out

any gas, and repeat steps 1-3 above. Smell for

gas, including near the ﬂ oor. If you smell gas,

stop, and follow the instructions on p. 1. If you

don’t smell gas, go on to the next step.

5. If the burner fails to light again, turn off the gas

at the source and contact the dealer or gas

supplier.

6. To extinguish the Real-Fyre

glass/pan burner,

simply turn the valve to the OFF position. Be

sure the valve is turned completely off to avoid

any gas leakage.

If your gas log set is operated by a Peterson manual safety pilot system (SPK Series) or a

Peterson remote safety pilot system (APK Series):

1. Carefully follow the lighting instructions supplied with your Peterson pilot system for the steps to

ignite the burner.