Owner`s manual

Manual On/Off Systems

AV-17 (knob) or AV-18 (rod handle) ................ Manual On/Off, match lit, no pilot

Manual Safety Pilot Systems*

SPK-20 (knob) or SPK-21 (rod handle) .......... Standard pilot

SPK-26 ........................................................... Low-proﬁ le valve

Remote Safety Pilot Systems*

APK-11, EPK-1 ............................................ Toggle switch

APK-11, EPK-1 and WS-1 ........................ Wall switch

APK-11, EPK-1 and WS-2 ......................... Wall timer

APK-11, EPK-1 and WCS-1 ..................... Wood chip switch

APK-11, EPK-1 and RRF-1 ....................... 110V remote

APK-11, EPK-1 and RUS-1 ....................... RUS remote

APK-11, EPK-1 and PC-100 ..................... Pine cone remote

APK-15, APK-17............................................... Variable ﬂ ame-height remote

PC-106 .......................... Pine cone remote

* When systems are to be used with propane gas, add a “P” to the control model No. (e.g., APK11P). Propane burner sets require a

safety pilot system. Not all safety pilot systems are available for all burner sizes.

INSTALLATION (Cont.)

Fig. 8-1

Fig. 8-2a Fig. 8-2b

Open

Closed

DAMPER

WHEN THE BURNER SET IS OPERATING, THE DAMPER MUST BE FULLY OPEN.

A damper clamp (Fig. 8-1) is provided as a means to prevent full closure of the ﬁ replace damper blade. This

clamp is easily attached to most damper blades with pliers or wrench, and must be permanently installed. The

clamp is designed to prevent accidental closure of the damper when installed as illustrated (Fig. 8-2a and

b). Should the damper clamp not ﬁ t, have a permanent stop installed.

MAINTENANCE

Periodically check burner for excessive dirt and soot. Clean with a soft brush. Be sure burner pan is ﬁ lled

with glass (see section on GLASS PLACEMENT).

Periodically examine and clean the venting system of the solid-fuel-burning ﬁ replace. This should be

conducted by a qualiﬁ ed professional or the gas supplier.

PETERSON CONTROL SYSTEM OPTIONS

When using a pilot/thermocouple, pilot/generator safety valve system, keep the pilot/assembly clear of sand,

glass, granules, etc. or pilot outage will occur, read and follow lighting instructions (included in safety pilot

kit).