Owner`s manual

7
INSTALLATION
1. Pour either sand (for natural-gas burners) or Lava-
Fyre Granules
TM
(for propane-gas burners) into
bottom of burner pan just below level of center
fl ame baffl e (Fig. 7-1 & 7-2).
2. Pour contents of glass bag to top of the pan rim
(Fig. 7-1 & 7-2). If safety pilot is used, make sure
to place the heatshield over the valve assembly
and cover the pilot before pouring glass to avoid
pouring it on the pilot.
This burner system must be installed by an NFI Certifi ed or other qualifi ed professional installer. Instructions must
be followed carefully when installing to ensure proper performance and full benefi t from the burner system.
Real-Fyre
®
gas burner sets must be installed only in a
solid-fuel-burning fi replace with fl ue, and constructed
of noncombustible material. Solid fuels shall not be
burned where a decorative appliance is installed.
Open damper fully and be sure damper clamp is in
place (see DAMPER STOP installation instructions).
Check PARTS LIST to be sure all parts are included.
Inspect to be sure the burner has air mixer or fuel
injection installed. For safe operation and proper
performance, use only Robert H. Peterson parts and
accessories. Gas-supply pipe must be ½" minimum
I.D. or larger (¾") if gas line is longer than 20'. REFER
TO PARTS LIST WHEN FOLLOWING THESE
INSTRUCTIONS.
BURNER PLACEMENT & ASSEMBLY
1. Turn off gas supply to the fi replace.
2. Clean fi replace fl oor of any ashes.
3. Place the pan as far back in the fi replace as
possible, centered right to left.
CONNECT GAS SUPPLY
Note: If your unit is to be installed with a safety
pilot kit, refer to the instructions supplied
with it for gas supply connection.
Using the CK-5 connector kit (Item #2), connect the
gas supply to the valve assembly inlet. Make sure
to attach the fl are fi tting between the corrugated
hose and gas-supply line. DO NOT KINK TUBING.
PIPE COMPOUND RESISTANT TO THE ACTION
OF PROPANE GASSES MUST BE USED ON ALL
THREADED MALE CONNECTIONS, EXCEPT
BRASS TO BRASS.
LEAK TESTING
Use a long-necked butane lighter, or lay a lighted
match next to the burner pipe, and carefully turn on the
gas supply until the burner ignites. Test for leaks at all
connections with a soapy water solution. Never use an
open fl ame to check for leaks. Turn off gas supply.
GLASS PLACEMENT
Important: Make sure the burner is off before
pouring glass and sand or Lava-Fyre
Granules
TM
.
Fig. 7-1
Fig. 7-2
Sand used for natural gas burner (Fig. 7-1); for
propane gas, use Lava-Fyre Granules
TM
under glass.
Failure to position the parts in accordance with
these instructions and diagrams, or failure to use
only parts specifi cally approved with this appliance,
can result in property damage or personal injury.
WARNING