Owner`s manual

ManualsBrandsR.H. Peterson ManualsBurner073 Series

No. L-A2-22609

REV 3 - 0903201116

This burner system is to be installed only in a solid-

fuel-burning ﬁ replace with a working ﬂ ue constructed

of noncombustible material. Solid fuels shall not

be burned in a ﬁ replace where a gas appliance

is installed. The minimum permanent vent open-

ing provided by the ﬁ replace chimney or chimney

damper to vent the ﬂ ue products is listed on p. 2.

The chimney damper must be ﬁ xed in a manner

to maintain the minimum permanent vent opening.

The installation, including provisions for combustion

and ventilation air, must conform with the American

National Standard National Fuel Gas Code Z223.1/

NFPA 54 and applicable local building codes.

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

If the information in this manual is not

followed exactly, a ﬁ re or explosion can

result, causing property damage, personal

injury, or loss of life.

Owner’s

Manual

PB SERIES GLASS/PAN BURNER SETS

Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the vicinity

of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Open a window.

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in the building.

• Immediately call the gas supplier from

a neighbor’s phone and follow the gas

supplier’s instructions.

• If you cannot reach the gas supplier,

call the ﬁ re department.

Installation and service must be performed

by an NFI Certiﬁ ed or other qualiﬁ ed

professional installer, service agency, or

the gas supplier.

INSTALLER & CONSUMER

These instructions MUST be retained

with this appliance.

Unregulated

Burner Systems:

PB-18(P)

PB-24(P)

PB-30(P)

DESIGN CERTIFIED

RGA2-72

for natural gas only

WARNING

Important: Read these instructions carefully

before starting installation of the

burner system.

Summary of content (10 pages)

PAGE 1
Owner’s Manual Unregulated Burner Systems: DESIGN CERTIFIED to RGA2-72 for natural gas only PB-18(P) PB-24(P) PB-30(P) PB SERIES GLASS/PAN BURNER SETS WARNING If the information in this manual is not followed exactly, a fire or explosion can result, causing property damage, personal injury, or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS: • Open a window. • Do not try to light any appliance.
PAGE 2
TABLE OF CONTENTS IMPORTANT SAFETY INFORMATION PARTS LIST IMPORTANT SAFETY INFORMATION (Cont.
PAGE 3
PARTS LIST PARTS LIST FOR PETERSON PB SERIES GLASS PAN BURNER (PB SERIES) 1 ITEM NO. 1. 2. DESCRIPTION Burner pan 1 CK-5 connector kit 1 Damper clamp 1 Glass * 1 Sand (nat.) or Lava-Fyre GranulesTM (propane) * 1 3. 4. 5. 2 QTY. 3 * Glass kits (which include sand/granules) are sold and packed separately.
PAGE 4
IMPORTANT SAFETY INFORMATION (Cont.) CAUTION: Installation and repair must be done by an NFI Certified or other qualified professional installer. Installer: Carefully read these instructions before installing this gas appliance. Be sure you understand all safety precautions and warnings contained in this manual. A. This appliance is designed as an attended appliance. Adults must be present when this gas appliance is operating. Do not leave this unit burning when unattended or while anyone is sleeping. B.
PAGE 5
GLASS QUANTITY DETERMINATION CAUTION: Sand is for use with natural-gas systems only. Always use R.H. Peterson Lava-Fyre Granules™ for systems using propane gas. The glass and either sand or lava that come with the burner system are pre-measured and must be used per these instructions (see GLASS PLACEMENT section). Additional decorative glass may be placed on or around the burner (but not on the valve or pilot). Use Table 5-1 to determine how many bags of glass to order based on fireplace size.
PAGE 6
NOTES PAGE Please use this page to record any information about your burner system that you may want to have at hand.
PAGE 7
INSTALLATION This burner system must be installed by an NFI Certified or other qualified professional installer. Instructions must be followed carefully when installing to ensure proper performance and full benefit from the burner system. Real-Fyre® gas burner sets must be installed only in a solid-fuel-burning fireplace with flue, and constructed of noncombustible material. Solid fuels shall not be burned where a decorative appliance is installed. 1.
PAGE 8
INSTALLATION (Cont.) DAMPER WHEN THE BURNER SET IS OPERATING, THE DAMPER MUST BE FULLY OPEN. A damper clamp (Fig. 8-1) is provided as a means to prevent full closure of the fireplace damper blade. This clamp is easily attached to most damper blades with pliers or wrench, and must be permanently installed. The clamp is designed to prevent accidental closure of the damper when installed as illustrated (Fig. 8-2a and b). Should the damper clamp not fit, have a permanent stop installed. Open Fig. 8-1 Fig.
PAGE 9
MANUAL LIGHTING INSTRUCTIONS FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion can result, causing property damage, personal injury, or loss of life. Do not use this appliance if any part has been underwater. Immediately call for a qualified professional service technician to inspect the appliance and to replace any part of the control system and any gas control that has been underwater.
PAGE 10
WARRANTY PETERSON VENTED DECORATIVE GAS APPLIANCE LIMITED WARRANTY All Peterson burner assemblies are WARRANTED for TEN (10) YEARS. All Peterson glass is WARRANTED for TEN (10) YEARS. SPK-26 controls are covered by a THREE (3) YEAR “All Parts” Warranty. All other Peterson valves, pilots, and controls are covered by a ONE (1) YEAR Limited Warranty (excluding batteries).