Owner`s manual

3
L-A2-017
REV 2-1005281303
CONNECTING WS-1 / WS-2 WIRE LEADS
TOGGLE SWITCH CONNECTION
1.
Connect the two female connector wire leads from the wall switch/mechanical timer to the two male
connectors on back of the toggle switch control (see Fig. 3-1). If there are no available male connectors,
you will have to disconnect the toggle switch wires and connect the wall switch/mechanical timer to the
back of the toggle switch. This will eliminate the use of the toggle switch and let you operate by the wall
switch/mechanical timer only. You can also choose to cut and strip the wall switch/mechanical timer
female wire leads and directly attach to the valve terminals (see Fig. 3-2).
Fig. 3-2
WALL SWITCH INCLUDES:
1 - Wall plate
4 - Flat head screws- MS-1 (2), MS-2
(1)
1 - Rocker switch- RS-1
1 - 15' 18GA lead wire
Fig. 3-1
MECHANICAL TIMER INCLUDES:
1 - Timer
1 - Knob
1 - 15' 18GA lead wire
1 - Nut
1 - Face cover
1 - Wall plate
2 - Flat head screws
2 - Screws with pressure plate
APK 10(M)
APK 11(M)
WALL
PLATE
FLAT HEAD
SCREW (2)
FLAT HEAD
SCREW (2)
FEMALE
CONNECTORS
CABLE LENGTH
NOT TO SCALE
TERMINAL
SCREWS
MS-1
MS-2
TOGGLE
SWITCH
CONTROL
WIRE LEADS TO
WALL SWITCH OR
MECHANICAL TIMER
MALE
CONNECTORS
FEMALE
CONNECTOR
OFF
ON
MALE
CONNECTORS
CONNECTING WALL SWITCH
WS-1
CONNECTING WALL SWITCH
WS-
2
WIRE LEADS
TO
SWITCH
WIRE LEADS
TO
GENERATOR
P
ILO
T
O
FF
TH PG
PG
ON
WIRE LEADS
TO
SWITCH
WIRE LEADS
TO
GENERATOR
IN