User Manual

Chapter 3: Using the Software
68 Series 6.0 Software (0510-1079-B) - User Guide
Transfer
The Transfer function is used to move a patient or asset from one protected area to another protected area, for
example from Labor and Delivery to Post Partum. Use the following steps to transfer a patient.
To perform a transfer
1. Click Transfer on the toolbar.
2. If necessary, use your proximity card or magnetic/barcode card or enter your Login and Password
then press Enter or click OK.
The Transfer window appears. Patients or assets with alarming band transmitters, Wander
Management transmitters or Pendant, Fall Monitoring or Incontinence devices that currently exist
in the census are listed in the window.
FIGURE 3.10: Transfer Window
3. Use the arrow buttons to find and select the patient or asset to be transferred.
4. Use the arrow buttons to find and select the Destination, or the location to which the patient or
asset is to be transferred.
5. Use the Increase or Decrease arrows to select the amount of time required for the transfer.
6. Click Transfer.
NOTE: If a transmitter is in alarm, the event must be cleared before the patient or asset
can be placed into Transfer.