User Manual

Series 6.0 Software (0510-1079-B) - User Guide 53
Common Operations
11. For an ICM transceiver the Supervised time defaults to the unit’s Transmitter Supervise Time,
set during configuration. However, you can select a different time from the drop-down list.
12. Select SAVE.
If the admit is successful, you will get the following dialog box:
13. Click OK.
For more information on the Transmitter tab, refer to “Enter Transmitter Information” on page 59.
To admit with a fixed device
1. Click Admit on the toolbar.
2. If necessary, use your proximity card or magnetic/barcode card or enter your Login and Password
then press Enter or click OK.
The Admit Selection window appears (refer to Figure 3.1 on page 49).
3. Select Manual Admit to bring up the Admit Information window.
4. Enter patient information; the yellow fields designate required entry.
5. Select the Room that was configured with device from the drop-down menu.
6. Click Save.
NOTE: To ensure supervision configuration changes are accepted by the Pendant
transceiver, it is important to alarm the Pendant after a change in device configuration.
NOTE: Pull Cords and Smoke Detectors are considered fixed devices. They are assigned
to a room and/or unit at the Configuration level. Refer to the Series 6.0 Software
Administrator Guide.