User Manual

Series 6.0 Software (0510-1079-B) - User Guide 39
The Main Window
Messaging
CHANGE MESSAGING SHIFT—It maybe necessary to change an page unit’s
work shift. Use this feature to select a different page unit and work shift. This feature
is configured by the System Administrator and can only be used if you currently use
pagers with your system. For more information, see the Series 6.0 Software
Administrator Guide.
START SHIFT—At the start of the shift, use this feature to check out a Cisco
phone. Cisco phones are configured by the System Administrator and can only be
used if you currently use Cisco phones with your system. For more information, see
the Series 6.0 Software Administrator Guide.
To check out a Cisco phone
1. Select Start Shift.
2. Use your proximity card or magnetic/barcode card or enter your Login and Password then press
Enter or click OK.
3. The Device Dialog window opens. Cisco phones currently available for checkout are listed in the
window.
FIGURE 2.7: Device Dialog
NOTE: The option to clear alarms at the point of care a feature of the Cisco phone. Below
are guide lines when clearing an alarm from the Cisco phone:
• If the “Clear” function is password protected, the user must be assigned that function
in order to clear an alarm from the Cisco phone. Additionally the phone or pager must
be checked out to the user assigned.
• The Cisco phone chimes when a message is cleared. It is important to select the
“When the event occurs” field concurrently with the “When the event is cleared”
field to avoid getting chimes without getting the original alarm message.