User's Guide
Table Of Contents
- Warnings
- Cautions
- Overview
- Intended Audience
- Contact Information
- Product Warranty
- Introduction
- Transmitters
- Transmitter Types
- Warranty Expiration Date
- Banding
- Using an Umbilical Cord Transmitter
- Discharging
- Transmitter Testing
- Transmitter Cleaning and Care
- Replacing the Clamp
- Smart Sense Transmitter
- Standard Infant Transmitter
- Patient (Locking) Transmitter
- Umbilical Cord Transmitter
- Transmitter Tester
General Information
Page 20 of 33 Safe Place Transmitters User Guide
0510-1121-J
7. With the red dot (labeled “Discharge”)
on the Activation Wand facing upwards,
place the tip of the wand on the image
of the yellow duck on the top of the
transmitter.
8. Hold the wand on the image for two
seconds and then pull away. Three red
LED blinks indicate the transmitter has
been discharged.
9. Finally, the transmitter must be
disinfected in order to be ready to be
used again.