User's Guide
Table Of Contents
- Warnings
- Cautions
- Overview
- Intended Audience
- Contact Information
- Product Warranty
- Introduction
- Transmitters
- Transmitter Types
- Warranty Expiration Date
- Banding
- Using an Umbilical Cord Transmitter
- Discharging
- Transmitter Testing
- Transmitter Cleaning and Care
- Replacing the Clamp
- Smart Sense Transmitter
- Standard Infant Transmitter
- Patient (Locking) Transmitter
- Umbilical Cord Transmitter
- Transmitter Tester
General Information
Page 18 of 33 Safe Place Transmitters User Guide
0510-1121-J
2. Leave enough length of the umbilical
stump beyond the clamp to prevent the
transmitter from falling off as the
umbilical stump reduces in size.
Discharging
When it is time for an infant to leave your
facility, he/she must be discharged from the
software (refer to the applicable Series
Software User Guide).
Banded
Transmitters
To discharge a banded transmitter:
1. Assure that clamps are firmly closed on
both sides with banding material in
place.
1. Check census screen to confirm that the
transmitter to be discharged is
communicating with the system
(indicated by Monitored displayed in
transmitter Status column).
2. Tend to and clear any alarms displayed
on the screen for the transmitter being
discharged.
3. Request a discharge function for the
transmitter and complete the action
within the allotted time specified in the
software by your facility.
4. Open the transmitter clamps to remove
the banding material.