User's Guide
Table Of Contents
- Warnings
- Cautions
- Overview
- Intended Audience
- Contact Information
- Product Warranty
- Introduction
- Transmitters
- Transmitter Types
- Warranty Expiration Date
- Banding
- Using an Umbilical Cord Transmitter
- Discharging
- Transmitter Testing
- Transmitter Cleaning and Care
- Replacing the Clamp
- Smart Sense Transmitter
- Standard Infant Transmitter
- Patient (Locking) Transmitter
- Umbilical Cord Transmitter
- Transmitter Tester
General Information
Safe Place Transmitters User Guide Page 15 of 33
0510-1121-J
Patient
(Locking)
To band a Patient transmitter:
1. Cut off 6-8” of the banding material from
the roll.
2. Verify that the transmitter is unlocked.
See the “Unlock a Transmitter” section
for further details.
3. Open the clamps of the transmitter by
gently pulling them outward, one clamp
at a time, from the top of the transmitter.
4. Insert the banding material through the
slot on the non-locking clamp side of the
patient transmitter, from bottom to top,
with the white side facing out.
5. Guide the banding material through until
it bumps against the stop.
6. Push in the clamp until it snaps into
place.
7. Insert the banding material through the
slot on the locking clamp side of the
transmitter, from bottom to top.
8. Guide the banding material through the
slot at the top of the clamp. DO NOT
snap the clamp into place.