Manualshelf

User's Manual

ManualsBrandsR F Technologies ManualsElectronicsQuick Response Premiere Router/Gateway
51525354555657585960
CHAPTER 2 Installing Transceiver Devices
Quick Response Premiere Wireless Call System Hardware Installation Guide Page 45 of 64
0510-1099-E
Door/Window Transceiver with Reset Button
If your Door/Window transceiver comes with a reset button, the alarm must be reset at the door by
pressing the reset button once the door/window is closed. The Door/Window transceiver comes in three
pieces: the transceiver enclosure, a magnet and a reset button. There are two types of reset buttons.
To mount the Door/Window transceiver with Reset Button
1. Mount the Door/Window magnet (refer to “To mount the Door/Window magnet to the door or
window” on page 47). The distance between the reed switch in the transceiver and the magnet must
be no more than 1/2 inch.
2. Mount the Door/Window transceiver (refer to “To mount the Door/Window transceivers using
mounting hole or “To mount the Door/Window transceivers with adhesive pad” on page 49).
Orientate the internal reed switch next to the magnet 3/8 inch away.
3. Mount the reset button.
To mount the Reset buttons
There are two types of reset buttons. The Universal transceiver comes pre-wired with 4 feet of
2- conductor 22 gauge wire. Route wire into door or window jamb and to the desired reset
button location.
To mount the reset button that has the round push button:
1. Use your fingers to remove the front cover.
2. Using the base of the reset button as a template, place it level against the door or wall and
mark the location of the two mounting holes.
3. Drill holes where you made the marks.
4. Line up the holes on the base of the reset button with the newly drilled holes and mount the
base using the screws provided.
5. Snap the front cover of the reset button back onto the base.
To mount the reset button that is labeled EMERGENCY:
1. Using the reset button as a template, place it level against the wall or door and mark the
location of the two mounting holes.
2. Drill holes where you made the marks.
3. Line up the holes on the base of the reset button with the newly drilled holes and mount the reset
button using the screws provided.