User's Manual

CHAPTER 2 Installing Transceiver Devices
Page 44 of 64 Quick Response Premiere Wireless Call System Hardware Installation Guide
0510-1099-E
To mount the Door/Window transceiver using mounting hole
NOTE: Orientate the internal reed switch next to magnet 3/8 inch away. The Universal
transmitter has been tested and shown to work as far as 1/2 inch.
1. Use your fingers to open the front cover of the transceiver by pushing the retaining
clip on the top downward. This allows the hinged cover to drop down and expose
the circuit board.
2. Carefully pull the circuit board free from the pins on the enclosure.
3. Drill a 1/8 inch mounting hole through the indentation in the transceiver enclosure.
4. Hold the enclosure against the door/window frame so that when the circuit board is
in place, the internal reed switch faces the magnet on the door.
5. Mark out the mounting hole and drill a 1/16 inch diameter hole where you made
the mark.
6. Line up the hole on the transceiver enclosure with the newly drilled hole and
mount the enclosure to the door frame with a number 6 screw (not included).
7. Pull the plastic battery tab to activate the battery or refer to the section entitled “To
replace the battery on a Door/Window transceiver” on page 51.
8. Return the circuit board onto the two pins.
9. Snap the front cover of the transceiver back into place.
To mount the Door/Window transceiver using mounting Plate
When mounting to a door or window jamb whose width is less than the width of the Door/Window
transceiver, use the provided plastic mounting plate.
1. Determine the location of the Door/Window transceiver.
2. Place the mounting plate in this location and mark the two mounting holes on the jamb.
3. Pre-drill the two holes using a 9/64" drill in the two marked locations.
4. Mount the plate using the screws provided.
5. Proceeded to the step 2 of the next procedure, To mount the Door/Window transceivers with
adhesive pad.
To mount the Door/Window transceivers with adhesive pad
The Door/Window transceiver can be attached using an adhesive pad that can be
purchased with the transceiver.
1. Determine where you want to mount the transceiver. The mounting surface must
be clean, dry and free of condensed moisture.
2. Pull the plastic battery tab to activate the battery or refer to the section entitled
“To replace the battery on a Door/Window transceiver” on page 51 to insert a
new battery.
3. Remove the adhesive plastic guard.
4. Hold the enclosure against the door/window frame so that when the circuit board is in place, the
internal reed switch faces the magnet on the door.
5. Firmly attach the transceiver to the door/window frame (or mounting plate). Ideal application
temperature range is 70°F to 100°F (21°C to 38°C).
6. Press firmly and hold for approximately 10 seconds to activate the pressure sensitive adhesive.
7. After application, the bond strength will increase as the adhesive flows onto the surface. At room
temperature, approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90%
after 24 hours and 100% after 72 hours.