User's Manual

CHAPTER 2 Installing Transceiver Devices
Page 42 of 64 Quick Response Premiere Wireless Call System Hardware Installation Guide
0510-1099-E
Setting the Universal Transceiver Up for Use
To set up the Universal transceiver for use
1. Activate the Universal transceiver by inserting the battery or remove the plastic battery tab.
2. Test the transceiver by activating the existing device.
3. If the transceiver is working properly, the Central Server will sense the Universal when it goes into
alarm and add it to the list of devices.
4. At the Central Server, update the transceiver information, for example, giving it a name and/or
assigning it to a room or unit. Refer to the “Update Devices” section in the Series 6.0 Software
Administrator Guide (PN0510-1080).
Replacing the Universal Transceiver Battery
1. To replace the battery in a Universal transceiver
2. Use your fingers to open the front cover of the transceiver by pushing the retaining clip on the top
downward. This allows the hinged cover to drop down and expose the circuit board.
3. Carefully pull the circuit board free from the pins on enclosure.
4. If changing the battery, use a small, non-conductive piece of plastic or wood to push the 3V Lithium
coin cell battery from the rear of the battery clip until it pops free.
NOTE: Do not use a metal screwdriver or metallic instrument to remove the battery. This may
damage the device.
5. Insert the 3V Lithium coin cell battery into the battery holder as shown. Be sure to align the positive
(+) end of the battery as marked on the battery and battery holder.
6. Verify communication by observing the LED light.
7. Return the circuit board onto the two pins.
8. Once communication is verified, snap the front cover of the transceiver back into place.