User's Manual

CHAPTER 2 Installing Transceiver Devices
Quick Response Premiere Wireless Call System Hardware Installation Guide Page 37 of 64
0510-1099-E
NOTE: To configure the Nurse Call transceiver for momentary or latching style call cords set the
jumper JP2 as shown in the following diagram:
Momentary Style
Latching Style
3. Center punch each hole and install two nylon wall anchors (included). If the call station is located
on a concrete wall then you must use the wall anchors designed for use with concrete (not included).
4. Snap the front assembly over the rear plate and place a screw (included) into the bottom of the
assembly (as shown below) to secure.