User's Manual

CHAPTER 2 Installing Transceiver Devices
Quick Response Premiere Wireless Call System Hardware Installation Guide Page 33 of 64
0510-1099-E
CHAPTER 2
Installing Transceiver Devices
Introduction
This chapter provides detailed information about installing transceiver devices and testing the operations of the
Quick Response Premiere Wireless Call System with supported devices. Transceivers are devices that transmit
and receive alarm data. The transceiver devices listed in this section are supported by the Quick Response
Premiere Wireless Call System running the applicable 6.0 Series or above Software application. The Quick
Response Premiere Wireless Call System includes transceivers that are carried by the patient and fixed devices.
A fixed device is a stationary device that is assigned to a room or a unit. Fixed devices are not transported with
the patient but stay in the room or unit to which they are assigned.
WARNING: Before cutting openings or drilling holes through walls, you must verify
that you will not strike any wiring or plumbing.
Transceiver Devices
The transceiver devices are entered into the system by placing the device. Upon power up the device will join
the Zigbee network. The devices will then appear in the device list under Configuration Devices.
NOTE: Pull Cords and Universal Transceivers check in every 20 minutes; Pendants check-in
every 100 seconds by default.
The user must then update the device information; for example, give the device a name and/or enable features
(refer to the applicable Series System Administrator Guide).
The Quick Response Premiere Wireless Call System transceiver devices consist of the following:
 Call Stations
o Pull Cord/Emergency Call
o Pull Cord with Check-In
o Push Button Emergency Call
o Nurse Call
 Universal Transceiver
 Door/Window Transceiver
 Pendant Transceiver
NOTE: Any transceiver devices that are to be assigned to a 32 Channel Controller must be on
the same PAN as the 32 Channel Controller.