User's Manual

CHAPTER 1 Installing Hardware Components
Quick Response Premiere Wireless Call System Hardware Installation Guide Page 21 of 64
0510-1099-E
32 Channel Controller System Power Up
1. Make certain that the power switch on the Router is OFF.
2. Turn the power switch on the 32 Channel Controller to OFF.
3. Turn the power switch on the 32 Channel Controller to ON.
4. Turn the power switch on the Router to ON. After the ON/OFF switch is turned to the ON
position the LED’s at the bottom of the device should flicker. If they don’t flicker then turn
the switch to the OFF position and then turn it back ON.
5. Secure faceplate of the 32 Channel Controller with six screws.
6. Proceed to configuring the 32 Channel Controller.
Wiring Diagram
This Wiring Diagram shows how the 32 Channel Controller is to be wired with a CPS.