User's Manual

CHAPTER 1 Installing Hardware Components
Quick Response Premiere Wireless Call System Hardware Installation Guide Page 17 of 64
0510-1099-E
32 Channel Controller
The 32 Channel Controller consists of a Quick Response Premiere Router, a 32 Channel
Controller relay board and up to 16 bi-color Dome Lights.
The 32 Channel Controllers are supervised; a routine signal is sent from each Quick Response
Premiere Router and if the signal is not received by the system, a Device Fault event is
generated in the Event List at the computer.
WARNING: It is crucial that the following steps be carried out in the order
listed. If the 32 Channel Controller is not powered and connected properly to
the Router when the Router is initially powered on, the controller will not
function. The 32 Channel Controller must be set to its assigned channel prior
to assigning devices.
Central Power Supply (CPS)
The Central Power Supply is used to connect the 32 Channel Controller and Dome Lights to a
single power source. The Central Power Supply eliminates the need to run 120VAC to each
detection zone. Note that the Router is powered by the 32 Channel Controller.
Refer to the Class II Central Power Supply Installation Guide (0510-1036) for detailed
information on installing the Central Power Supply.
Install the 32 Channel Controller
Installing the 32 Channel Controller consists of first running the wires from all the Dome Lights
to the 32 Channel Controller and CPS Power, of installing the 32 Channel Controller, the
Router and the Dome Lights. The units must be wired per the wiring diagram (see page 19).
WARNING: When installing a product, you must follow standard, accepted
safety practices, such as wearing safety glasses.