User's Manual

CHAPTER 1 Installing Hardware Components
Page 14 of 64 Quick Response Premiere Wireless Call System Hardware Installation Guide
0510-1099-E
Quick Look Router
A Quick Look Router is a Quick Response Premiere Router connected to a wireless Quick
Look Display or High Visibility Display. When an alarm is sent from the Server to the Router,
the wireless display shows the type of alarm, location data and transceiver number. As new
alarms occur, they appear immediately; the display then begins scrolling through each active
alarm.
NOTE: The location data displayed depends on configuration. If a Gateway/Router is
assigned to a room, the Quick Look displays the room and unit data. If the Router/
Gateway is assigned to a unit only and not individual rooms, the nearest location data is
displayed.
The Quick Look Router also acts as an integral part of the back-up reflector mode. This
reflector mode functionally allows the Quick Response Premiere network to take over the
responsibility of distributing alarm information (transceiver number only) to the Quick Look
Routers in the event of an inoperable Server. In reflector mode it will display device names and
the nearest Router that received the alarm.
Quick Look Routers are supervised; a routine signal is sent from each Quick Look Router and if
the signal is not received by the system, a Device Fault event is generated in the Event List at
the computer.
WARNING: Quick Look Routers should not be added to multiple units. Since
Routers are used to determine location, inaccurate location data
could result.