User Manual

9600 Series Wireless Call System (0510-1078-D) - Hardware Installation Guide 33
Installing Transceiver Devices
To mount the Nurse Call transceiver
1. Using the rear enclosure of the Nurse Call as a template, place it level against the wall at the desired
mounting height and mark the location of the two mounting holes.
2. Center punch each hole and install two nylon wall anchors (included). If the Nurse Call is located
on a concrete wall then you must use the wall anchors designed for use with concrete (not
included).
3. Place the Nurse Call enclosure over the wall anchors in
alignment with the holes in the enclosure and insert two
screws (included).
4. With the Universal transceiver in place, secure the Nurse
Call faceplate to the rear enclosure with two screws. Be
careful not to pinch wires.
To set up the Nurse Call for use
1. Plug in the desired Nurse Call Cord set into the Nurse Call.
2. Activate the Nurse Call by pressing the button.
If the Nurse Call is working properly, the Central Server will sense the Nurse Call when it goes into
alarm and add it to its list of devices.
3. Reset the Nurse Call by pulling the button back to the UP position.
4. At the Central Server, update the Nurse Call information, for example, giving the Nurse Call a
name and/or assigning it to a room or unit. Refer to the “Update Devices” section in the Series 6.0
Software Administrator Guide (PN 0510-1080).