User Manual
Table Of Contents
- Important Warnings
- Bio-Incompatibility Notice
- Compliance
- Introduction
- About this Guide
- Additional Detailed Documentation
- Contact Information
- Product Warranty
- Chapter 1
- Introduction
- Installation Checklist
- Installing Components
- Install the Central Server
- Install the Gateway
- Install Routers
- Place a Pendant into Survey Mode
- Determine Placement of Routers
- Quick Look Router
- Gateway/Router Reset Button
- LED Sequence
- Gateway/Router Channel Default
- Additional Gateway/Router Installation
- Changing Channels
- Router Depth
- Rebuild Subnet on Scanned Devices
- Scan Devices
- Chapter 2
- Introduction
- Transceiver Devices
- LED Light Indicator
- Installing Transceiver Devices
- Pull Cords/Emergency Call
- Check-in Pull Cord
- Pull Cord Transceiver with Extended Battery Pack
- Wall Mount Emergency Call
- Universal Transceiver
- Tamper
- Nurse Call
- Door/Window Transceiver
- Door/Window Transceiver with Reset Button
- PIR Sensor
- Smoke Detector
- Pendant Transceivers
- Activate the Battery
- Set up the Pendant
- Reset the Pendant
- Verify the Pendant Appears in the System
- Replace the Battery
- Test the System Operation
- Chapter 3
- Introduction
- Device Failure
- Router Failure
- Gateway Failure
- Chapter 4
- Specifications
- Power Cable Run Lengths
- Mesh Network Router/Gateway
- Quick Look Display for Quick Look Router
- Pendant Transceiver
- Pull Cord
- Nurse Call
- Door/Window Transceiver
- PIR Sensor
- Smoke Detector
- Universal Transceiver
Chapter 2: Installing Transceiver Devices
24 9600 Series Wireless Call System (0510-1078-D) - Hardware Installation Guide
Pull Cord Transceiver with Extended Battery Pack
The Pull Cord Transceiver can be either surface mounted or flush mounted. Due to the size of the Extended
Life Battery Pack a surface mount enclosure or single gang enclosure will be required to house the battery
holder. The following sections provide detailed steps on how to mount the transmitter using both methods.
To surface mount the Transceiver
1. Hold the base of the surface mount enclosure against the wall at the desired mounting height.
2. Mark the location of the two mounting holes.
3. Drill holes where the marks were made. If the drilled holes do not hit a stud wall, you must use wall
anchors.
4. Line up the holes on the base of the enclosure with the newly drilled holes.
5. Mount the base of the enclosure to the wall using two drywall screws.
6. Determine the desired length of the pull cord string. The standard length of a Pull Cord strings is six
feet long. However, as mounting heights vary, the length of the string may need to be adjusted.
7. Connect the battery pack to the pigtail connector on the Pull Cord assembly.
8. Make certain that the pigtail wires leading from the Pull Cord Assembly pass through the cutout in
the back enclosure cover and that they are not pinched.
9. Place the pull cord assembly aligned over the mating holes in the surface mount enclosure and
secure in place with the two screws provided.
NOTE: Do not over tighten the screws as this will cause the alarm lever to bind and thus
not release correctly.