User Manual

Chapter 1: Installing Hardware Components
8 9600 Series Wireless Call System (0510-1078-D) - Hardware Installation Guide
Place a Pendant into Survey Mode
A Pendant in Survey Mode is used to survey the coverage area when installing Routers. Any Pendant
transceiver can be configured for Survey Mode. While in Survey Mode the Pendant periodically blinks either
green or red, depending on whether or not it is in range of a Router. Pressing the button on a Pendant in
Survey Mode does not generate or clear alarms.
Prepare Pendant for Survey Mode configuration
1. Insert the 3V Lithium coin cell battery into the Pendant.
2. Allow the Pendant to sit “untouched” for two minutes while it downloads the site’s channels.
3. Remove the battery from the Pendant.
To configure a Pendant for Survey Mode
1. Hold down the button on the Pendant transceiver.
2. While holding the button down, insert a 3V Lithium coin cell battery into the battery holder of the
Pendant transceiver.
3. Continue holding the button down until you see the light blink (approximately 2 seconds).
The Pendant blinks green or red every 1 1/2 seconds. Green indicates that the Pendant is within
range of a Router; red indicates the Pendant is outside of the coverage area.
To take a Pendant out of Survey Mode
1. Remove the 3V Lithium coin cell battery from the Pendant
2. Insert a “new” battery into battery holder of the Pendant. Do NOT hold the button down.
The Pendant is now ready for normal use (refer to “Pendant Transceivers” on page 40).