User Manual

Chapter 3: Using the Software
52 Series 6.0 Software (0510-1065-A) - User Guide
6. In the TX ID field, type the 3-digit ID number printed on the alarming band transmitter to be
assigned to the patient.
7. Click Female or Male to indicate the gender of the patient.
8. Click the Risk level for abduction or elopement associated with the patient. Choices are Low, Medium
or High.
9. In the Unit field, select the unit to which the patient is currently assigned, even if the patient will not
remain in that unit (required).
10. In the Room field, select the patient’s room number.
11. In the Birth Date field, enter the patient’s birthday (two digit month, two digit day, four digit year).
12. In the Discharge Planning Date field, enter the planned date of discharge (the appearance of this field
depends on your system configuration)
13. In the Training Delivered field, indicate the type of training material used by entering the date training
was delivered to the patient or patient’s family.
Asset Main Information Tab
The Asset Main information tab allows you to enter identification information about the asset being admitted.
The yellow fields designate required entry.
1. Click Main on the toolbar.
2. In the Model field, type the model or description of the asset being admitted (required).
3. In the Make field, type the manufacturer’s information of the asset being admitted.
4. In the SN field, type the serial number of the asset being admitted.
5. In the TX ID field, type the 3-digit ID number printed on the alarming band transmitter to be
assigned to the asset.
6. In the Unit field, select the unit to which the asset is currently assigned, even if the asset will not remain
in that unit (required).
7. Click the Risk level associated with the asset. Choices are Low or High. If your facility has enabled the
Lockdown on Cut Band Alarms feature, a Cut Band Alarm will trigger a Global Lockdown when a High
Risk level is selected for an asset transmitter.
NOTE: The following characters are invalid and should not be used when entering main
information: ,+”&’‘%#/