User Manual

Series 6.0 Software (0510-1065-A) - User Guide 23
Fall Management System
Fall Management System Control Unit
The Fall Management System Control Unit is connected to a Fall Management System Sensor Pad and attached
to a patient’s bed or chair, out of reach of the patient. If a patient attempts to get up, the Control Unit sounds an
alert. An alert can be annunciated in the form of a buzzer. Staff can also be alerted via your facility’s nurse call
system or the software. An Assistance Required alarm is activated in response to a Fall Management System alert
when interfaced with the Series 6.0 Software. The Control Unit is powered by a 9-volt alkaline battery or by a
plug-in power supply.
Fall Management System Sensor Pad
Fall Management System Sensor Pads can be used on most standard beds or chairs in your facility. They are
disposable, intended for single-patient use, and warranted for 7, 30, 90, or 180 days. The Sensor Pads
have a limited expected useful life. You must record the date the warranty expires in the area provided
on the label. You must not use the sensor pad after the in-service warranty has expired.
WARNING: If the keys on the Control Unit are worn or damaged, you must
stop using the Control Unit and contact RF Technologies.
WARNING: Pad may become damaged when used on a dynamic mattress (air,
water, etc.). Correct operation should be confirmed at every patient rotation.