User's Manual

WARNING
SYSTEM MAINTENANCE AND TESTING—It is the responsibility of the
facility to establish and facilitate a regular maintenance schedule for your
system, as outlined in the applicable system guides. This includes regular
inspection, testing, and cleaning. RF Technologies, Inc. recommends
monthly maintenance and testing of your system. It is also recommended
that your facility keep records of maintenance and test completions.
Failure to provide regular maintenance and testing of these products
may result in equipment and/or system failure.
WARNING
SYSTEM WIRING—All permanent supply connections must be done in
accordance with National Electric Code, NFPA 70.
WARNING
USER TRAINING—Only users who have received adequate training on the
use of the system, as outlined in this manual, should use the system. It is the
responsibility of the facility to ensure all users have been trained.
Failure to adequately train employees may cause system failure due to
user error. In addition, incorrect use of the equipment may also result
in system failure.
WARNING
WORN OR DAMAGED PARTS—If the control unit pads or cables are
worn or damaged, you must have the product serviced. For more
information, see the section entitled “Service and Return.”
WARNING
All RF Technologies transmitters, pendants and banding material
“PRODUCT” have been determined to be MR Unsafe as defined by ASTM
F 2503-05. Use of “PRODUCT” in a Magnetic Resonance Imaging system
will cause injury to patients and staff, MR system malfunction or
“PRODUCT” malfunction. Do not bring “PRODUCT” into the MR system
area and follow your facilities policies to classify and label “PRODUCT” as
MR Unsafe.
CAUTION
DISPOSAL—At the end of their service life the products described in this
manual, as well as accessories (i.e. lithium batteries, banding material,
disposable pads, etc.), must be disposed of in compliance with all applicable
federal, state and local guidelines regulating the disposal of products
containing potential environmental contaminants. Dispose of the packaging
material by observing the applicable waste control regulations.