User Manual

WARNING
SYSTEM MAINTENANCE AND TESTING—It is the responsibility of the facility
to establish and facilitate a regular maintenance schedule for your system, as
outlined in the current Series Software Administrator Guide. This includes regular
inspection, testing, and cleaning. RF Technologies, Inc. recommends monthly
maintenance and testing of your system. It is also recommended that your facility
keep records of maintenance and test completions.
Failure to provide regular maintenance and testing of these products may result in
equipment and/or system failure.
WARNING
SYSTEM WIRING—All permanent supply connections must be done in
accordance with National Electric Code, NFPA 70.
WARNING
USER TRAINING—Only users who have received adequate training on the use of the
system, as outlined in this manual, should use the system. It is the responsibility of the facility
to ensure all users have been trained.
Failure to adequately train employees may cause system failure due to user error. In
addition, incorrect use of the equipment may also result in system failure.
WARNING
WORN OR DAMAGED PARTS—If the control unit pads or cables are worn or damaged,
you must have the product serviced. For more information, see the section entitled “Service
and Return.”
WARNING
All RF Technologies transmitters, pendants and banding material “PRODUCT”
have been determined to be MR Unsafe as defined by ASTM F 2503-05. Use of
“PRODUCT” in a Magnetic Resonance Imaging system will cause injury to patients
and staff, MR system malfunction or “PRODUCT” malfunction. Do not bring
“PRODUCT” into the MR system area and follow your facilities policies to classify
and label “PRODUCT” as MR Unsafe.
CAUTION
DISPOSAL—At the end of their service life the products described in this manual,
as well as accessories (i.e. alkaline battery, disposable pads, etc.), must be disposed
of in compliance with all applicable federal, state and local guidelines regulating the
disposal of products containing potential environmental contaminants. Dispose of
the packaging material by observing the applicable waste control regulations.