User Manual

Chapter 1: The Smart Sense Transmitter
12 Smart Sense Infant Transmitter (0510-1093-C) - User Guide
Replacing the Clamp
In some cases, you may need to replace damaged Smart Sense transmitter clamps.
This is done by opening the existing clamps, snapping them off of the Smart Sense
transmitter, and inserting new clamps.
To replace a Smart Sense transmitter clamp
1. Open the clamps all the way and gently remove them from the transmitter.
2. Insert the first clamp into the Smart Sense transmitter by inserting the left oval-shaped
pin into the hole on the left of the Smart Sense transmitter.
3. Next, line the right oval-shaped pin up with the hole on the right side of the Smart
Sense transmitter.
4. Gently snap the right oval-shaped pin into the hole.
5. Close and secure the clamp.
6. Repeat the previous steps for the second clamp.
WARNING: Use care around the piercing contacts on the
Smart Sense transmitter as they are extremely sharp. Placing
your fingers directly on the piercing contact can result in injury.
Transmitter with both Clamps snapped closed.
Open Clamps
Left Hole
Right Hole
Right Oval-Shaped
Left Oval-Shaped