User Manual

The Smart Sense Transmitter
Smart Sense Infant Transmitter (0510-1093-C) - User Guide 11
Discharge of the Smart Sense Transmitter
When it is time for an infant to leave your facility, he/she must be discharged from the
software. The Smart Sense transmitter must be removed from the infant within the period of
time specified in the software by your facility.
To discharge the Smart Sense transmitter
1. Assure that clamps are firmly closed on both sides with banding material in place.
2. Check census screen to confirm that the transmitter to be discharged is communicating
with the system (indicated by Monitored displayed in transmitter Status column).
3. Tend to and clear any alarms displayed on the screen for the transmitter being
discharged
4. Request a discharge for the transmitter and complete the action within the allotted time.
• Open the Smart Sense transmitter clamps to remove the banding material.
• Do not slip the banding material off infant’s extremity; doing so may
result in a Band Off alarm.
• Do not leave the banding material in the Smart Sense transmitter clamps
after discharge; doing so may result in the transmitter re-enrolling.
5. Discard the used banding material (refer to the Disposal caution in the Important
Warnings section of this guide).
6. Finally, the transmitter must be disinfected in order to be ready to be used again.