User Manual

Chapter 1: The Smart Sense Transmitter
6 Smart Sense Infant Transmitter (0510-1093-C) - User Guide
Required Transmitter Testing
You must test all transmitters prior to use to verify proper operation. This includes
every time that the band is replaced.
Required testing prior to placing transmitter on infant.
N
OTE: All of these steps are mandatory.
1. Verify that the warranty expiration date that is stamped on the transmitter has not
expired.
2. Visually inspect the transmitter for damage or loose parts.
3. Test the operation of the transmitter using the transmitter tester. The transmitter tester
will detect whether or not a transmitter is emitting a signal, but cannot indicate the
strength of the signal.
a. Band a transmitter on both sides with approved
banding material.
b. Press and hold the button on the left side of the
transmitter tester.
c. The tester beeps once when you initially press the
button.
d. Continue to hold the button for the duration of the
process.
e. Place the transmitter (that is banded on both sides
with approved banding material) directly on top of
the transmitter tester.
WARNI NG: Do not use the transmitter tester on a transmitter with an
expiration date that has expired. Results may not be accurate. Do not use
a transmitter beyond its expiration date.
CAUTION: Failure to test the transmitters before use can result in
system failure and/or an abduction. In addition, failure to test
transmitters voids the RF Technologies’ Product Warranty.
Indicator Light
Press and hold the button