User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 77
Transfer
8. A dialog box appears showing the patient’s or asset’s name, the amount of time allowed to transfer
the patient or asset, and the destination.
If the Transfer is for a Wander Management transmitter, Pendant, Fall Monitoring or Incontinence
device, the transfer occurs immediately.
9. Click Confirm to confirm the Transfer.
As soon as the patient's or asset’s transmitter passes through a protected zone that belongs to the
selected designation, the system recognizes that the transfer was successful and the Transfer
completes.
10. Click Cancel or X to cancel the Transfer request and close the window.
To reset a transfer duration time
1. Select Login (or Functions if password protection is disabled).
2. Enter your Login and Password or use your identification card.
3. Click Transfer.
The Transfer window appears (Figure 3.12 on page 76). Patients or assets that currently exist in
the census are listed in the window.
4. Use the arrow buttons to find and select the patient or asset whose transfer duration time is to be
reset.
5. Use the Increase or Decrease arrows to select the new time needed to transfer the patient or asset.
6. Click Reset Duration.
A dialog box appears showing the patient or asset name and the number of minutes that the transfer
is extended.
7. Click OK.
NOTE: When a transmitter successfully transfers to a unit with a different setting for
Band Slippage, a Begin Adjust alarm may be generated upon completion of the transfer.