User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 57
Admit Functions
To admit with a Pendant, Fall Monitoring or Incontinence device
1. Alarm then reset the device.
2. Select Login (or Functions if password protection is disabled).
3. Enter your Login and Password or use your identification card.
4. Click Manual Admit.
The Admit Selection window appears.
5. Enter patient information; the yellow fields designate required entry.
6. Select the Transmitter tab.
7. Select the Transmitter ID number (printed on Pendant) from the pull-down.
8. Click Add
The Admit Information window appears allowing you to select the transmitter type.
FIGURE 3.3: Admit Information to Select Transmitter Type
9. Select the Transmitter Type from the pull-down menu.
• Pendant
• Fall Monitoring
• Incontinence
10. For a QR transmitter the Supervised option is selected by default. If desired, deselect it.
NOTE: The Transmitter tab will not appear until a QR Transmitter ID Range is
configured into the system (refer to the Series 7.0 Software Administration Guide).