User's Manual

Chapter 2: Software Features
48 Series 7.0 Software (0510-1086-B) - User Guide
If a transmitter location changes, for example if an alarm is activated while the transmitter is in motion, the
receiving device closest to the transmitter triggers the alarm. The icon representing the receiving device
flashes on the Client computer map. Below is a table of how devices are displayed on the map in the Main
Window
.
Devices Assigned to a Room
Devices assigned to a room will not show on the map until the room
device goes into alarm. The map will display the room to which the
alarming device is assigned. By clicking on the alarming device icon, you
can bring up details of the device. If more than one device is assigned to a
room, details on both devices are displayed. Click OK to dismiss the
device detail. The icon will continue to flash until the alarm is cleared.
Help
Click Help to access the on-line help window for the Series 7.0 System. Here you can navigating through
user help topics.
Silence
You can click Silence to stop the alarm sound. The alarm is silenced for the configured length of time;
however, the event still appears in the Event List. The next event automatically restarts the alarm sound. This
Silence button is green when the Silence feature is turned ON. To configure the Alarm Silence Time-out,
refer to Series 7.0 Software Administrator Manual.
Normal Mode Alarming Device Fault
Green Flashing Red Flashing Yellow