User's Manual

Chapter 1: Equipment Overview
34 Series 7.0 Software (0510-1086-B) - User Guide
Incontinence Sensor Pad
The Dri Tec Incontinence sensor pad comes on a roll and is perforated in one-foot sections to allow you to
tear off only what is needed. It is recommended that you use three sheets for a bed and one for a chair. Prior to
tearing, fold at the perforation to ensure that the pad tears freely from the roll.
The Dri Tec sensor pad connects to the control unit via the Dri Tec Sensor Cord. When an incontinence event
is detected, the control unit beeps twice every second to alert caregivers. A red status indicator light flashes in
conjunction with the beeps for a visual alert.
Advanced 4-Way Care with Nurse Call
To use the Advanced 4-Way Care System with the Nurse Call accessory, connect the Nurse Call
modular jack cable to the control unit. Then connect the Nurse Call cord set into the modular jack. Nurse Call
monitoring starts when the cord set is connected.
When a patient pushes the button on the Nurse Call cord set, an Assistance Required alarm is generated. The
control unit beeps once every 3-seconds to alert caregivers and a red status indicator light flashes in
conjunction with the beeps for a visual alert.
NOTE: The Nurse Call cord set is gravity fed and must always be positioned upright as
shown. False nurse calls may occur if not positioned properly.