User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 25
9600 Series Wireless Call System
Pendant Transceiver
A Pendant transceiver is a wireless, mobile transceiver that can be worn around the
neck or wrist, or attached to a belt. The protective boot protects the Pendant transceiver
against dropping and water ingress. However to prevent water damage, avoid
prolonged submersion and direct contact with a water stream.
The Pendant can be supervised; if no information is received by the system from the
Gateway for a specified number of times, a No Signal alarm is generated in the Event
List at the computer. Since the Pendant is a mobile device, no installation is required.
Simply insert the battery and set up the Pendant transceiver for use. The Pendant is
powered by a replaceable 3-volt battery. When the battery is low, the Pendent
sends a Low Battery notification.
To Call for Assistance
To call for assistance, firmly press and hold the blue button on the transceiver (for
about a second). Release the button, the green light flashes a series of times to indicate
the transceiver is in an alarm state. If the transceiver flashes red, the signal is blocked.
Move to another area of the room until the signal transmits (flashes green).
To Clear an Alarm
To clear an alarm or to reset the Pendant transceiver, rapidly but firmly press and
release the blue button on the transceiver six (6) times within three (3) seconds (be sure
to see the green light flash for each push). The green light flashes a series of times to
indicate the transceiver has changed states and is now idle and ready for its next usage.
If the transceiver flashes red, the signal is blocked. Move to another area of the
room until the signal transmit (flashes green).
WA R N I N G: You must replace the Pendant battery within
seven days after receiving a Low Battery notification.
Flashing green light