User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 19
9600 Series Wireless Call System
Quick Look Router
A Quick Look Router is an 9600 Series Router connected to a wireless Quick Look Display or High
Visibility Display. When an alarm is sent from the Server to the Router, the wireless display shows the type
of alarm, location data and transceiver number. As new alarms occur, they appear immediately; the display
then begins scrolling through each active alarm.
The Quick Look Router also acts as an integral part of the back-up reflector. Reflector functionally allows the
9600 Series network to take over the responsibility of distributing alarm information to the Quick Look
Routers in the event of an inoperable Server.
Quick Look Routers are supervised; a routine signal is sent from each Quick Look Router and if the signal is
not received by the system, a Device Fault event is generated in the Event List at the computer.
32 Channel Controller Router
The 32 Channel Controller Router is a 9600 Series Router connected to a 32
Channel Controller. When an alarm is sent from the Server to the Router, the 32
Channel Controller acts as a relay switch and turns on the Dome Light mounted
outside the patient’s room. The Dome Light includes two indicator lights: a white
indicator light for low priority alarms and a red indicator light for high priority
alarms.
32 Channel Controller Routers are supervised; a routine signal is sent from each
Quick Look Router and if the signal is not received by the system, a Device Fault
event is generated in the Event List at the computer.
WA R N I N G: Quick Look Routers should not be added to multiple units. Since
Routers are used to determine location, inaccurate location data could result.