User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 1
Preface
Overview
The Series 7.0 Software supports the 9450 Series, Quick Response (QR), 9500 Series Wired Call and 9600
Series Wireless Call Systems. This guide provides detailed information about the Series 7.0 Software, using
the software and using system reports. It also provides an overview of the systems as well as an equipment
overview.
9450 System
The 9450 System monitors doors, elevators, hallways, and stairwells, to assist staff in monitoring patients and
assets in a facility. The various transmitters and devices of the system alerts staff if a transmitter’s banding
material is tampered with, cut or opened without authorization (referred to as Cut Band for Infant and
Emergency Department systems only) or if monitored devices in the system are not functioning properly.
The Smart Sense technology combines the Smart Sense Infant Transmitter and Banding Material to give you
three additional measurements for tamper detection (referred to as Band Off for Infant and Emergency
Department systems only).
• Temperature—change in transmitter temperature
• Resistance—no motion detected from the banding material (i.e. band stretching with
normal infant movement)
• Capacitance—change in contact between transmitter and infant
An alarm also sounds if a transmitter is detected in an Exit Alarm Zone. If the system fails to detect a
transmitter within its monitored area, a No Signal alarm is issued.
Depending on which equipment options your facility has installed, the 9450 System can automatically lock
doors and deactivate elevators. In addition, the system sounds an alarm at the Central Server and its network
of Client computers when the event occurs. If configured, alarms are also annunciated at remote notification
locations (i.e. pagers, walkie-talkie, Quick Look Interface).
With the Mother/Infant Matching feature activated, an alarm is generated if there is a mismatch, meaning the
Infant and Mother transmitters do not match; a linking error, meaning there is a problem linking the Infant
transmitter to a Mother transmitter; or if a discharge is attempted without first matching the Infant transmitter
with the Mother transmitter.
NOTE: The Mother/Infant Matching feature is included in the software; however, if
your facility is not currently configured for Mother transmitters, the Mother/
Infant Matching feature IS NOT ACTIVE. For more information, contact RF
Technologies Technical Support at [phone] or [phone].