User's Manual

Series 7.0 Software (0510-1086-B) - User Guide 117
Event Types
Transfer to Expire
This alarm occurs when the time allowed for a patient to be transferred will expire in the configured time (if
the allotted time was configured for greater than 15-minutes) and the alarming band transmitter, in the
Transfer mode, has not been moved from one protected area to another.
To respond to a Transfer to Expire
1. Determine the location of the patient.
2. If the patient is secure and will not be transferred to a protected area soon, clear the Transfer to
Expire alarm and reset the duration time for the Transfer.
3. If the patient has not yet been moved, clear the Transfer to Expire alarm and cancel the Transfer.
Transfer Expired
This alarm occurs when the selected amount of time required for a patient to be transferred has expired and
the alarming band transmitter, in the Transfer mode, has not reached its destination.
To respond to a Transfer Expired Alarm
1. Determine the location of the patient.
2. From the Client computer, click anywhere in the Transfer Expired Alarm Message Box to access
the Event Information window.
3. Select one of the following event causes:
• Patient Delayed—the patient was delayed and needs more time for the transfer.
• Failed to Start—the Transfer was never started; or the patient was never transferred.
• Transfer Completed—the patient was successfully transferred to the destination.
• Te s t—the system was being tested.
• Other—opens a Clear Reason window, user must enter the cause in this window.
You cannot clear an event until you select the appropriate cause for the event.
4. If the patient has not yet been transferred, perform the Transfer function again.
5. If the patient has left the initial unit but has not arrived at the transfer unit:
a. Bring the patient through the door of the unit to which they are being transferred; a Door
Alarm may occur.
b. Follow the procedures for handling a Door Alarm (refer to “Door Alarm” on page 98).
c. Select Transfer problem for the cause of the Door Alarm.
d. If No Signal alarms occur, contact an Administrative user to manually transfer the transmitter
to the new unit.
Transfer Completed
This alarm occurs when a Transfer for a patient is completed. This dialog box only appears if the software has
been configured to confirm the transfer.The Confirm Transfer is configured in the Configuration, Global
Settings menu (refer to the Series 7.0 Software Administrator Guide).