User's Manual

Chapter 3: Using the Software
92 Series 7.0 Software (0510-1086-B) - User Guide
Start Shift
At the start of the shift, use this feature to check out a Cisco phone. Cisco phones are configured by the
System Administrator and can only be used if you currently use Cisco phones with your system. For more
information, see the Series 7.0 Software Administrator Guide.
To check out a Cisco phone
1. Select Start Shift.
2. Use your proximity card or magnetic/barcode card or enter your Login and Password then press
Enter or click OK.
3. The Device Dialog window opens. Cisco phones currently available for checkout are listed in the
window.
FIGURE 3.26: Device Dialog
NOTE: The option to clear alarms at the point of care a feature of the Cisco phone. Below
are guide lines when clearing an alarm from the Cisco phone:
• If the “Clear” function is password protected, the user must be assigned that function in
order to clear an alarm from the Cisco phone. Additionally the phone or care manager
must be checked out to the user assigned.
• The Cisco phone chimes when a message is cleared. It is important to select the “When
the event occurs” field concurrently with the “When the event is cleared” field to
avoid getting chimes without getting the original alarm message.